Обрати для іншої країни
troubleshooting troubleshooting
Місцезнаходження:Головна > troubleshooting > laser cutter machine > X-axis not moving at all
Image-1

Thunder Laser відео


Як вибрати надійний лазерний різак

ДИВИТИСЯ ЗАРАЗ
▷ Як вибрати надійний лазерний різак
laser parametes

Thunder Laser відео


Параметри зразків лазера

ДИВИТИСЯ ЗАРАЗ
▷ Параметри зразків лазера

X-axis not moving at all

Время выпуска:2018/11/17 laser cutter machine Время просмотра:521

Here are the reasons:


● X-axis limit switch problem

Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below.
some trouble of laser cutter
If they both seem to be well, please test is x-axis limit switch working properly according to the video below.
https://www.youtube.com/watch?v=oOy1HFAufu8


● The interface of x-axis motor have bad connection

If the x-axis limit switch is working properly, please open upper right hand door panel, check if the interfaces of x-axis motor are connected well, like below.
some trouble of laser cutter
Please power off the machine, re-connect the interface then try again.


● Motor or driver of x-axis is broken

Please open lower right hand door panel, check the x-axis driver (red LED should be up and flashing), like below:
some trouble of laser cutter
Please power off the machine, then swap two drivers according to the video below.
https://www.youtube.com/watch?v=LC6lW1YFLvM

After that, power on the machine, check if the machine is resetting normally.
If x-axis still not moving at all, so the x-axis motor is broken;
If the problem shifts to y-axis, the same driver is flashing red light, so this driver is broken.


End.