Thunder Laser відео
Як вибрати надійний лазерний різакДИВИТИСЯ ЗАРАЗ
Thunder Laser відео
Параметри зразків лазераДИВИТИСЯ ЗАРАЗ
The laser tube won’t fire the beam
Время выпуска：2019/06/01 laser cutter machine Время просмотра：304
Here are the reasons:
● The laser switch is off
Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing sign of receiving power — fans is running and power light is up, like below.
Note: The machine before Apr. 2018 had been installed another type of laser power supply, like below.
● Laser power supply or laser tube is worn out
Please test the laser power supply itself, first take off the plug of control signal, like below.
Then press the red button to test, check if electric current (on screen or ammeter) changing and laser tube has laser beam comes out according to the video below.
If both electric current and laser tube are nothing, please check if the laser power supply is showing sign of energy output — making “zizi” sound.
If yes, the laser tube should be worn out, otherwise, laser power supply fails.
● Laser path or machine parameters issue
If both electric current and laser tube are working, please put back the plug of control signal.
Then restore your machine to factory setting, try that first to eliminate machine parameters issue, like below.
Operate the LCD panel;
Z/U button>>“set default para”>> Password:HF8888.
In the end, press reset button.
If the laser beam won’t come out form the laser head, please align the mirror according to the video below.
След.: X-axis not moving at all
- Engraving problem—the engraving quality is...
- The machine won’t turn on
- Alarm message of LCD panel—Machine protected
- Chiller alarms unusually
- Air pump won’t work or no air assis...
- Cutting problem– Some point of the s...
- Why noisy while moving laser head front an...
- Why the red dot pointer not being able to ...