Обрати для іншої країни
067 3812333

Sales Email: andrei@procompact.com.ua

troubleshooting troubleshooting
Місцезнаходження:Головна > troubleshooting > laser cutter machine > Cutting problem– Some point of the same piece of materials cannot be cut through
Image-1

Thunder Laser відео


Як вибрати надійний лазерний різак

ДИВИТИСЯ ЗАРАЗ
▷ Як вибрати надійний лазерний різак
laser parametes

Thunder Laser відео


Параметри зразків лазера

ДИВИТИСЯ ЗАРАЗ
▷ Параметри зразків лазера

Cutting problem– Some point of the same piece of materials cannot be cut through

Время выпуска:2019/06/01 laser cutter machine Время просмотра:163

Here are the reasons:

● The needed focus is lost

some trouble of laser engraver
The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic.
Please fix the material with magnet and check if the working table are the same height, then calibrate according to the link below.
https://www.thunderlaser.com.ua/troubleshooting/how-to-calibrate-the-working-table-to-level.html


● The focus lens and reflective mirror are dirty

some trouble of laser engraver some trouble of laser engraver


● The laser beam path is not aligned

1. Mirror alignment;
When the laser head move to four corners of the working table, check if the laser beam lasers to the same position on the third reflective mirror.
some trouble of laser engraver

2. Vertical alignment;
When the laser head moves to four corners of the working table, check if the laser beam can vertically go through the 10mm acrylic.
some trouble of laser engraver
Please check laser beam path according to the video below.
https://www.thunderlaser.com.ua/how-to-use-your-laser-machine/how-to-adjust-the-laser-beam-path.html


End.