Обрати для іншої країни
067 3812333

Sales Email: andrei@procompact.com.ua

troubleshooting troubleshooting
Місцезнаходження:Головна > troubleshooting > General Question > Maintenance manual for Thunder laser system
Image-1

Як відрегулювати шлях лазерного променя


Image-1

Як встановити нову лазерну трубку


Maintenance manual for Thunder laser system

Время выпуска:2019/07/08 General Question Время просмотра:258

Maintenance manual for Thunder laser cutterProper care and routine maintenance of the machine will ensure optimal performance over a long service life.

DAILY CHECK LIST

☑ Focus lens

WEEKLY CHECK LIST

☑ Reflector ☑ Laser combiner ☑ Keep machine clean

MONTHLY CHECK LIST

☑ Rails and Screws ☑ Laser beam path ☑ Exhaust fan ☑ Water Chiller
● DAILY CHECK LIST
• Focus lens
1.Remove the laser head                2. Divide the laser head
Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
3. Remove the focus lens with the tool           4. Clean the lens with lens cloth
Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
Note: The direction of focus lens mounting please refer to below picture:
● WEEKLY CHECK LIST
• Reflector
Use a lens cloth and lens cleaner to keep all mirrors clean Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
• Laser beam combiner
Use a lens cloth and lens cleaner to keep combiner lens clean. Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
• Keep machine clean
Remove these small pieces that fall into the honeycomb table and collected in the machine using small brush or vacuum cleaner. Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
● MONTHLY CHECK LIST
• Rails and Screws
Add lubricant oil (or Rust Preventative Grease) to all rails on X&Y axis.
Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
Maintenance manual for Thunder laser cutter
Add lubricant oil (or Rust Preventative Grease) to four Z axis screws
Maintenance manual for Thunder laser cutter Maintenance manual for Thunder laser cutter
• Laser path
1. Mirror alignment;
When the laser head move to four corners of the working table, please check if the laser beam lasers to the same position on the third reflective mirror.
Maintenance manual for Thunder laser cutter
2. Vertical alignment;
When the laser head moves to four corners of the working table, please check if the laser beam can vertically go through the 10mm acrylic.
Maintenance manual for Thunder laser cutter
Please check laser beam path according to the video below.
https://www.thunderlaser.com.ua/how-to-use-your-laser-machine/how-to-adjust-the-laser-beam-path.html
• Exhaust fan
Clean the air intake
Maintenance manual for Thunder laser cutter
• Water chiller
Change the pure (distilled) water and clean the filters;
Note: if water drains slowly from drainage nozzle during water changing, please open the water supply inlet.
Maintenance manual for Thunder laser cutter
More detail please refer to the Chapter 5 Maintenance of User’s Manual.
End