Обрати для іншої країни
067 3812333

Sales Email: andrei@procompact.com.ua

laser cutter machine machine

Місцезнаходження:Головна >troubleshooting >laser cutter machine
Image-1

Thunder Laser відео


Як вибрати надійний лазерний різак

ДИВИТИСЯ ЗАРАЗ
▷ Як вибрати надійний лазерний різак
laser parametes

Thunder Laser відео


Параметри зразків лазера

ДИВИТИСЯ ЗАРАЗ
▷ Параметри зразків лазера

  • Why the red dot pointer not being able to come out from the laser head.

    Why the red dot pointer not being able to come out from the laser head.

    Время выпуска:2019/06/01Время просмотра:343

    Here are the reasons: ● The red dot pointer is off Locate on the Red Dot Pointer Mount in the rear of the machine, and check if the Red Dot Pointer is off, like below. If yes, please open the lower...

  • Chiller alarms unusually

    Chiller alarms unusually

    Время выпуска:2019/06/01Время просмотра:281

    Chiller lcd panel is showing normal, but the red light on and buzzer beeping. Here are the reasons: ● Water is not enough Please check the water level of chiller, like below: Keep the water level i...

  • Air pump won’t work or no air  assist when job starts

    Air pump won’t work or no air assist when job starts

    Время выпуска:2019/06/01Время просмотра:230

    Here are the reasons: ● Air compressor break down How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then ch...

  • Exhaust fan cannot extract smoke  or dust

    Exhaust fan cannot extract smoke or dust

    Время выпуска:2019/06/01Время просмотра:195

    Here are the reasons: ● Exhaust fan break down How to check if exhaust fan break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if...

  • Cutting problem– Some point of the same piece  of materials cannot be cut through

    Cutting problem– Some point of the same piece of materials cannot be cut through

    Время выпуска:2019/06/01Время просмотра:202

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large cutting graphic. Please fix ...

  • Engraving problem—the engraving quality is very poor

    Engraving problem—the engraving quality is very poor

    Время выпуска:2019/06/01Время просмотра:203

    Here are the reasons: ● The needed focus is lost The bending of the material or the uneven working table can result in different focal lengths, especially for the large engraving graphic. Please fi...

  • The laser tube won’t fire the beam

    The laser tube won’t fire the beam

    Время выпуска:2019/06/01Время просмотра:235

    Here are the reasons: ● The laser switch is off Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing sign ...

  • X-axis not moving at all

    X-axis not moving at all

    Время выпуска:2018/11/17Время просмотра:199

    Here are the reasons: ● X-axis limit switch problem Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below. If they both seem to be wel...